This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

httpproxy not working right?

I am nearly completely unable to browse the web when Web Filtering is enabled with 9.314.13 installed. I have rebooted twice since installation. Browsing is normal when I disable Web Filtering. As soon as it is re-enabled, browsing goes to crap (never finishes loading a page). I will begin scouring the logs, but thought I would check and see if you guys had seen this after updating. This is for a home user license, so no support.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

A couple of others have reported similar, which were resolved by fresh install, then restoring config-backup. First try restoring a config-backup and see if just that helps. If you are using syslog, which the sourcetype indicates, you can also try disabling syslog (Logging & Reporting > Log Settings > Remote Syslog Server) temporarily and see if it helps.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

A couple of others have reported similar, which were resolved by fresh install, then restoring config-backup. First try restoring a config-backup and see if just that helps. If you are using syslog, which the sourcetype indicates, you can also try disabling syslog (Logging & Reporting > Log Settings > Remote Syslog Server) temporarily and see if it helps.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data