Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 1 subscriber
  • Views 1123 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Configuring http and other proxies with seperat internet interfaces

rfcat_vk
HI,
I have merged two UTMs, one uses IPv6 sixxes tunnel and the other used a native IPv6.
I have setup the connctions on two seperate interfaces and have internet access through the new link with policy routing and firewall rules.

How do I setup the connections so that traffic from the seperate zone goes out the link with the native IPv6 through the http proxy?

Ian M


This thread was automatically locked due to age.
  • 0
    If it were me, I'd use Uplink Balancing and Multipath Rules to achieve this.
    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
  • 0 in reply to Scott_Klassen
    Back to square one, my configuration broke mail. So, I will try the path you have suggested.

    Ian[[[:)]]][[[:)]]][[[:)]]]

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk
    I tried uplink balancing and multi-path rules which worked fine for about 15 minutes then mail failed along with internet becoming very slow on all interfaces. Deleting configurations doesn't work, I had to install and old config file, then start slowly again.

    The bug with the multi-path tab and not being able to dis-able multi-path without deleting the interfaces is still there. I was under the impression this was fixed many versions ago? Yes, you can turn it off, but that does not disable it.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk
    I have come to the conclusion that what I am trying to do does not work.

    So, it is back to two UTMs.

    Ian M

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

Unfiltered HTML