This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ACC V3 and Hyper-V R2 SP1 Problem

Hallo,

I'm trying to install the new Astaro Command Center V3 as a Hyper-V R2 SP1 Guest VM.

Based on ISO-Image "acc-3.000-10-1.iso" and a VM configured with 1 vCPU, 1GB RAM and 1 NIC (old compatible DEC 21140) the setup runs fine.

After the first restart the ACC guest recognizes that it runs as a Hyper-V guest and begins to install VMBUS drivers.

But after registering several child devices and initializing Heartbeat channel and Shutdown channel functionality the boot process stops without any further messages.

Has anyone an idea to solve this problem?

Best regards, FrankLin

This thread was automatically locked due to age.

0 Scott_Klassen over 12 years ago

Does the reboot stall at the same place after a Turn Off and Start?

I just installed to W2k8R2 SP1 Hyper-V last night and had to do a hard kill myself, but after that everything was fine.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 FrankLin_01 over 12 years ago in reply to Scott_Klassen

Hallo Scott,

yes, the reboot stall at the same place after a reset or a power off/on cycle.

Do you make some special configurations for the guest vm, e.g. integration services feature option?
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 12 years ago

Nothing special. All integration services offered, 1GB RAM, 1 virtual processor, and 1 network adapter. The only two things that I can think of are to check the md5 of the ISO that you downloaded and try to install again with a new VM.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 FrankLin_01 over 12 years ago in reply to Scott_Klassen

Hallo Scott,

I've downloaded the latest iso-file and re-created the VM on several different Hyper-V R2 SP1 (based on W2K8R2SP1 Standard and Enterprise) Hosts, but the result is always the same (the boot process hangs at VMBUS Driver install, see attachement).

Do you have any idea?

FrankLin
Cancel
Vote Up 0 Vote Down

Cancel