This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ACC Configs: Best Practice

I am getting ready to deploy an ACC to manage a Multi Astaro setup and was wondering what others have done for best practice.

I was initially going to place the ACC behind a NAT rule but I am rethinking that design. Since this setup will be managed remotely I thought it might be better to have the ACC on a public IP in the event a bad config breaks the NAT rule and renders the device inaccessible.

This thread was automatically locked due to age.

0 Simon Shaw over 13 years ago

Mine's NAT'ed from a public IP. If it's inaccessible it's not a big issue for us.
We mostly use ACC for central up2date management and birdseye view of availability/licensing.
Cancel
Vote Up 0 Vote Down

Cancel
0 Joe_Halleck over 13 years ago in reply to Simon Shaw

Good point.
Did you discover all the ports needed for proper operation when behind a NAT? I didn't want to waste a full IP address on the NAT. I assume 4422 but have not dug into the doc enough to determine if any other ports are needed for communications.
Cancel
Vote Up 0 Vote Down

Cancel
0 Simon Shaw over 13 years ago

We're using port 4433.
Cancel
Vote Up 0 Vote Down

Cancel
0 Joe_Halleck over 13 years ago in reply to Simon Shaw

Simple NAT on 4422 and 4433 did the trick.
Cancel
Vote Up 0 Vote Down

Cancel