This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need some advice on how to get my UTM (software ) to work as a proxy.

I have a unusual setup, Hope the rough sketch describs it:

 

The Ipad gets its IP from DHCP server running on Router A, but I would like it to use web proxy for content filtering using the UTM

however when I put in the IP address of either of my virtual Nic's on the UTM it does not browse the web.

The UTM has 2 Nics configured at preset both using dhcp Server from router A

one of them has the IP of Router A as its gateway.

could some one please assist to help me work out where I am going wrong.

On the Ipad I went under the Wifi settings and added manual proxy settings with IP address of the UTM (tried both nics) and with port 80 & 8080 neither of them worked.

regards,

Medi



This thread was automatically locked due to age.
Parents Reply Children
No Data