Thread Info
  • State Suggested Answer
  • +2 person also asked this people also asked this
  • Locked Locked
  • Replies 15 replies
  • Answers 3 answers
  • Subscribers 7 subscribers
  • Views 34085 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED15w Access Point not showing up as pending access point

MarkusSonderegger

Hi

We use 8 RED15w  for roadwarriors. We run the RED's in Standard/Unified mode, bridged to the LAN in the same IP Segment.

Users behind the RED can connect to all resources in the LAN Segment, DHCP and DNS are working fine.

But the only thing is, the RED15w will not be recognized as Access Points in Wireless Protection as pending Access Points.

The existing AP55C AP's are working fine.

Wireless Networks (3) are setup with Algorithm AES, one is bridged to LAN and the others are in separate segments.

Any idea why?

Thank you and best regards Markus



This thread was automatically locked due to age.
Parents
  • +1

    Same Problem here, with DHCP Relay:

    Solution: https://community.sophos.com/kb/de-de/119131

    Example: Configuration of DHCP option 234 on Windows Server 2008

    1. Logon to your Windows Server 2008 and open the DHCP configuration.
    2. Select the applicable DHCP server in the tree and click on "Predefined Options"
    3. Now click on "Add" 
    4. Provide the following information:
      Name:<freely selectable>
      data type: IP address
      Code: 234
    5. Click OK
    6. Now select the newly added option in the list above and add the IP address of the interface where the AP is connected to(192.168.205.2 in our example)
    7. Then right-click on "Server Options" and select "Configure options"
    8. Now tick the option 234 and click on Apply to activate the option for your server
Reply
  • +1

    Same Problem here, with DHCP Relay:

    Solution: https://community.sophos.com/kb/de-de/119131

    Example: Configuration of DHCP option 234 on Windows Server 2008

    1. Logon to your Windows Server 2008 and open the DHCP configuration.
    2. Select the applicable DHCP server in the tree and click on "Predefined Options"
    3. Now click on "Add" 
    4. Provide the following information:
      Name:<freely selectable>
      data type: IP address
      Code: 234
    5. Click OK
    6. Now select the newly added option in the list above and add the IP address of the interface where the AP is connected to(192.168.205.2 in our example)
    7. Then right-click on "Server Options" and select "Configure options"
    8. Now tick the option 234 and click on Apply to activate the option for your server
Children
No Data
Unfiltered HTML