Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 3 subscribers
  • Views 3768 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED 50 in Bridge Br0 in Split Mode not processing WEB Protection Rules

Mark_D

Hi All

I have a UTM and RED in Bridge Mode br0.

When in this mode the Traffic though the Red is not following the Web Protection Rules, but it is fine if it is an Interface.

If I enter an IP address of a client into the Policy Helpdesk it shows the correct Policy.

Thoughts

Mark



This thread was automatically locked due to age.
Parents
  • 0

    Mark, if you still want to work on this, please describe the bridge more specifically.  Are you saying that you have reds1 bridged to eth0 so that the remote office is on the same subnet as the main office?

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0

    Mark, if you still want to work on this, please describe the bridge more specifically.  Are you saying that you have reds1 bridged to eth0 so that the remote office is on the same subnet as the main office?

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Unfiltered HTML