Hi Guys,
we do have a issue with RED50 Vlan configuration. In our Setup we do use Red50 and then connected different CISCO Switch models. We want to have a trunk port on the Red and we configured also a trubk port on cisco side. Then on Cisco we defined some access port matching to the different VLAN from that trunk. When we then connect a client nothing happens? What did we wrong?
However when the client is direct attached to the trunk port from the RED50 and then NIC is configured to be in one of the specific VLANs transported in that Trunk, we get the IP addresses from that networks.
When the Switch is added it does not work?
Is there a general way of configuring the Cisco switch to match to the Trunk Port from the RED50?
This thread was automatically locked due to age.