This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED10 - Configure each LAN

aza2001 over 9 years ago

Hi,

I can't find any information on this (maybe my googlefu is out?)

anyway I want to configure
LAN1 192.168.18.x
LAN2 192.168.19.x
LAN3 192.168.20.x
LAN4 192.168.21.x

is this possible?

Also if the remote site has multiple WAN connections can say LAN1 etc be used as a failover port?

Regards,
Az

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

is this possible?
All of the LAN ports are bridged, so no.

Also if the remote site has multiple WAN connections can say LAN1 etc be used as a failover port?
Also no. For WAN failover, you would need a RED50.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

is this possible?
All of the LAN ports are bridged, so no.

Also if the remote site has multiple WAN connections can say LAN1 etc be used as a failover port?
Also no. For WAN failover, you would need a RED50.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data