Hi Folks,
I want to use the same subnet on a remote site as I have in my Headquarters.
Clients on the remote site should get IP-adresses from the UTM via DHCP
I have connected a Red 10-device to my UTM (V9.310-11) without further configuration. I converted the Internal Interface of the UTM to "Ethernet Bridge" and added the Red-Interface to the bridge.
On the remote site I connected a computer to the Red Device and everything seems to work, the computer gets an ip-address through DHCP from the Headquarters. Even Internet-Surfing does work.
But: I cannot connect to another machine on the HQ-Subnet.
The only machine I can ping through the bridge is the UTM.
Are there any firewall rules / filters I have to set up?
I have checked the firewall rules but nothing seems to be a problem.
But because the Red-Device is bridged I can´t see it in the network-definitions so I am not able to set up special rules like "Any from RED to Any ->allow"...
Any suggestions? Thx!
Andre
This thread was automatically locked due to age.
