This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED 10 Rev. 3 Boot loop with LED Sequence *video*

I have a RED 10 at a remote location that has the following LED sequence: https://www.youtube.com/watch?v=segvsK0_1_Q 

It seems to do this for a few minutes and then reboot.  I can ping it remotely while it is doing this sequence, but then drops which I'm assuming it is resetting itself.  The troubleshooting guide doesn't mention this sequence: https://www.sophos.com/en-us/support/knowledgebase/116573.aspx The closest it gets in the firmware update, but that is only on Rev. 1 devices, and this is a Rev 3. 

I am not at the location, so I haven't tried using the firmware recovery tool, but I may have to drive over there.  Any thoughts or suggestions?


This thread was automatically locked due to age.
Parents Reply Children
No Data