Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 20 replies
  • Subscribers 2 subscribers
  • Views 21787 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

tunnel utm -> utm

PieterH
I setup i red-connection between 2 utm 9 devices.
The status tells me that the connection is established but no traffic is go from or to the other network
In the red-log I see these lines:
2013:08:11-14:39:47 fw red_server[10798]: 7543d61167ee40f: PING remote_tx=61 local_rx=62 diff=-1 
2013:08:11-14:39:47 fw red_server[10798]: 7543d61167ee40f: PONG local_tx=61 
I have made firewall-rules to allow traffic between the networks.
I also made Masquerading rules on both sites for the other networks.
What am i doing wrong?


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to PieterH
    @Pieterh

    do you have applied a bridge over the RED interfaces setup a transfer network?
    Please show us the screenshots from interface and bridging section.



    @BAlfson
    bridging is a nice solution, but because there is only one bridge possible and there might be slow WAN connection, I use the transfer Network setup, like you would do when you connect two routers. 
    Problem with the routing setup is, you must managed the routes by hand or setup OSPF. But be careful and setup a static route to the RED Endpoint first, otherwise you might try to establish the tunnel through the tunnel and this is not working.

    Sven

    Astaro user since 2001 - Astaro/Sophos Partner since 2008

Unfiltered HTML