Hello,
I am currently running some tests using a RED connection between two UTM appliances. So far this seems to be very stable and more easily maintainable than IPSec Site2Site.
My current setup is that on my HeadQuarter appliance I have defined an interface on the redsN device for each branch I want to connect. On the branch office UTM appliance, I have bridged the redsN device to the internal.
On my HQ UTM I can no enable QoS on the RED interface and configure it to reserve a certain amount of bandwidth for the individual protocols. The RED interface on the HQ UTM does have the bandwidth of my external WAN link set in the interface definition. From HQ to branch, the QoS is working fine.
On the other direction, from branch to HQ, I would need to activate QoS on the internal interface. This seems to cause the bandwidth reservations not to work correctly, since my internal interface is usually defined as 1Gbit, whereas the actual bandwidth of the WAN connection the RED uses is much lower.
Is it possible to configure the RED connection in a way that I have a RED interface defined on both appliances headquarter and branch office?
Thanks.
best regards
Martin
This thread was automatically locked due to age.
