This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Rename RED Branch Name??

Hi
We have a UTM220 running firmware 9.100-16 and about 12 RED10 devices. The reds are named "reds01, reds02 ..." etc. I would like to give these more descriptive names, but I see that in the WebAdmin there doesn't seem to be a way. Am I missing something?

Is there *any* way to do this, even via a manual config/xml edit? When we get an alert that "redXX is down" it would be really helpful to not have to dig up my notes on which site that actually is.

This thread was automatically locked due to age.

Parents

0 stealthmatt_01 over 11 years ago

It makes sense why its set to like reds1 reds2 etc

its like the ethernet interface eth1 eth2

It does give you the option to add a short name so I am not really sure why you would need to change the interface name.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 stealthmatt_01 over 11 years ago

It makes sense why its set to like reds1 reds2 etc

its like the ethernet interface eth1 eth2

It does give you the option to add a short name so I am not really sure why you would need to change the interface name.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 luckman212 over 11 years ago in reply to stealthmatt_01

I don't want to change the interface name (reds01) I want to change the "Branch Name" -- the description -- e.g. "123 Main St".
Cancel
Vote Up 0 Vote Down

Cancel