This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED 50 not work Split

Hi All,

We just deploy the RED 50 in our environment and we got a problem.

Today we have one RED10 in your enviroment working in Standard/Split mode and its works correctly.

But put the RED50 to working in Standard/Split defitely not work, its works only in Standard/Unified.

If we put the RED50 in Standard/Split mode the RED50 side do not access any networks.

Then we leave the RED50 working as Standard/Unified but its not our desire.

Note: Red50 are in the same rules in firewall/nat/maskerading etc like the red10

The Firmware version is 9.006-5.

I sent 3 images about the configurations.

Any one can help ?

thx.

This thread was automatically locked due to age.

Parents

0 Marc M over 11 years ago

Unbeliveble, I put both (Address) and (Networks) objects and RED 50 start works fine as Standard/Split, everythink is ok with RED 50 now.

And I certify, if I remove the (Address) objects the comunication is stop, if I back the (Address) its back, the same occurs with (Networks) objects if I remove its stop, if I back it works, so to work is need put the both in Standard/Split Box.

Only FYI in the my RED 10 only (Networks) objects is need to work.

Anyone knows why it occurs with RED 50 now ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Marc M over 11 years ago

Unbeliveble, I put both (Address) and (Networks) objects and RED 50 start works fine as Standard/Split, everythink is ok with RED 50 now.

And I certify, if I remove the (Address) objects the comunication is stop, if I back the (Address) its back, the same occurs with (Networks) objects if I remove its stop, if I back it works, so to work is need put the both in Standard/Split Box.

Only FYI in the my RED 10 only (Networks) objects is need to work.

Anyone knows why it occurs with RED 50 now ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data