This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED 50 not work Split

Hi All,

We just deploy the RED 50 in our environment and we got a problem.

Today we have one RED10 in your enviroment working in Standard/Split mode and its works correctly.

But put the RED50 to working in Standard/Split defitely not work, its works only in Standard/Unified.

If we put the RED50 in Standard/Split mode the RED50 side do not access any networks.

Then we leave the RED50 working as Standard/Unified but its not our desire.

Note: Red50 are in the same rules in firewall/nat/maskerading etc like the red10

The Firmware version is 9.006-5.

I sent 3 images about the configurations.

Any one can help ?

thx.

This thread was automatically locked due to age.

Parents

0 BAlfson over 11 years ago

Hi, Marc,

Prepare yourself for a facepalm moment...

Your RED 50 Split configuration uses the "(Address)" objects instead of the "(Network)" objects.

Cheers - Bob
PS Is the ASG hostname really the same for both of the RED 50's connections?

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 11 years ago

Hi, Marc,

Prepare yourself for a facepalm moment...

Your RED 50 Split configuration uses the "(Address)" objects instead of the "(Network)" objects.

Cheers - Bob
PS Is the ASG hostname really the same for both of the RED 50's connections?

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data