This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem with red after update to 9.100-16

hello,

after update to 9.100-16 the red gets its firmware and after reboot or shutdown the reds comes never online again.

any ideas or hints?

the red blinks constantly on system, router,internet, tunnel is dark

and then the red restarts to the same procedure.

kind regards,

sebastian

This thread was automatically locked due to age.

Parents

0 treskaan over 11 years ago

Hi Hartmut,
your partner did indeed give you a wrong advice. The reflashing tool is for RED10 only. I bet you see an ugly error message in your red.log. We have a bug in version 9.100 that the firmware update will fail if the process takes longer then 3 minutes and fixed it in version 9.101. If you update everything should be fine.
Greetings Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 treskaan over 11 years ago

Hi Hartmut,
your partner did indeed give you a wrong advice. The reflashing tool is for RED10 only. I bet you see an ugly error message in your red.log. We have a bug in version 9.100 that the firmware update will fail if the process takes longer then 3 minutes and fixed it in version 9.101. If you update everything should be fine.
Greetings Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data