This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SELF: RED client can only be run in master mode

trying to get a RED 10 connected to our ASG 320.  Have the RED device setup in the UTM 9 with the correct RED ID.  The lights on the front get to the point where the tunnel light is flashing then it cycles through again after throwing this message:

2013:01:11-12:09:57 fw-1 red_server[13209]: SELF: (Re-)loading device configurations
2013:01:11-12:09:58 fw-2 red_server[7875]: SELF: (Re-)loading device configurations
2013:01:11-12:09:58 fw-2 red_server[7875]: SELF: RED client can only be run in master mode 

any ideas?


This thread was automatically locked due to age.
Parents Reply Children
No Data