This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Guest Network behind RED

At my HQ I have a ASG320 running UTM 9. We have several wireless AP50 units powering our wireless network. We have a wireless network bridged to the main network and then a wireless network isolated from the main network for guests.

I would like to send a RED device to one of our branch offices and have a similar setup there with an wireless network for employees and then a wireless network that is separated for guests. I have had no problems getting the wireless network for employees set up behind the RED device but I can't figure out how to set up a isolated separate network for guests.

Any suggestions?

This thread was automatically locked due to age.

0 treskaan over 12 years ago

Just add the RED interface to your allowed wireless interfaces, plugin the AP into one of the LAN ports, wait until it's up and group your wireless networks as usual.
Greetigs Andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 MJonesPro over 12 years ago in reply to treskaan

This is what i did to setup the employee wireless network in the branch office. I want to set up an additional guest wireless network that is segmented from the employee network though.
Cancel
Vote Up 0 Vote Down

Cancel
0 treskaan over 12 years ago

You can create another SSID for guests, isolate it in the advanced settings and group it with your RED AP as well.
Cancel
Vote Up 0 Vote Down

Cancel