Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 2 subscribers
  • Views 3155 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Port forwading in split tunnel mode

Xfiring
Is it possible to have port forwarding work with a RED in split tunnel mode?

So the scenario is that all computers on the red network will be getting dhcp and dns from the central asg.  What I'd like to do is have external traffic that comes in to the asg's public ip at say port 7000 directed to a particular ip address (computer) on a specific RED network. And when traffic would come in on say port 8000 have that go to a specific ip (computer) on a different ReD network. 

Thanks.


This thread was automatically locked due to age.
Parents
  • 0
    Can you explain full nat vs dnat in split tunnel RED terms? 

    If someone would be kind enough to show me what gets filled in where under the Full Nat setup, I would appreciate it.  I can't seem to figure out exactly where the port and IP numbers get defined in there.

    Thanks.
Reply
  • 0
    Can you explain full nat vs dnat in split tunnel RED terms? 

    If someone would be kind enough to show me what gets filled in where under the Full Nat setup, I would appreciate it.  I can't seem to figure out exactly where the port and IP numbers get defined in there.

    Thanks.
Children
No Data
Unfiltered HTML