This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG With 2 WAN Links; Flush RED Device through 2nd WAN

The title essentially describes what I need to configure. We have a second WAN connection that I'd like to connect to a free eth port on an ASG120. It happens to be on the same subnet as a the RED device but it's across the street from our main location. I currently have the RED configured and working as a Static IP but connecting to the main WAN connection on the ASG (2 separate network providers; lots of hops between).

I need some assistance in setting up the ASG's second WAN connection and then allowing it to handle the RED traffic through this connection instead. Being on the same subnet should save some latency so this can only benefit the connection.

Any input from the expert pool would be wonderful!

Thanks,
Joe

This thread was automatically locked due to age.

Parents

0 peterkieser over 13 years ago

Please keep in mind that the RED connects to your Astaro, and not vica-versa. You will need to specify an IP address/hostname of your other connection in the RED configuration for it to work as desired.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 peterkieser over 13 years ago

Please keep in mind that the RED connects to your Astaro, and not vica-versa. You will need to specify an IP address/hostname of your other connection in the RED configuration for it to work as desired.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data