Hello,
First time setting up a RED device. We have a few branch offices most with TLS connections but we have one office where we are going to use a RED device to connect them to our home network. We want it set so all traffic (except local traffic) goes over the RED to our home office for web filter, email, etc.
I have attached a little diagram as to how I want to set it up but I just want to make sure I understand how the RED device will behave.
Also, in the initial setup of the RED on the ASG 220 V8, I added the RED device, but when I go to add the Interface under Interfaces & Routing it asks for a IPv4 address, what IP Address do I use, the one I assigned to the RED?
Please provide feedback if you can!
This thread was automatically locked due to age.
