This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

red crashes after configuration

Hallo,

I try to reconfigure a red-device.
After saving the config the red doesn t come back. System and internet lamps are off. Power off and on restarts the device an the connection comes up again.
Any hints what is going wrong?

Thanks

Ralf

This thread was automatically locked due to age.

0 christianlouis over 13 years ago

Does the device still act "dead" ?
Also, what do you mean by "reconfigure"?

Which LEDs are active, which ones are not?
Cancel
Vote Up 0 Vote Down

Cancel
0 rprengel over 13 years ago in reply to christianlouis

Does the device still act "dead" ?
Also, what do you mean by "reconfigure"?

Which LEDs are active, which ones are not?

The device is working now.
Power of an on once more and a fresh configuration (deleting the device first in the astaro) worked.

Ralf
Cancel
Vote Up 0 Vote Down

Cancel
0 hunter1vv over 13 years ago in reply to rprengel

Hi,

I have a similar problem. Everything works fine after changing configuration from DHCP to Static. It worked for some days, but now only the Power-LED ist on. Nothing else happens or starts blinking.

Restarted many times and reconfigured the RED but there is still only the Power-LED on.
Cancel
Vote Up 0 Vote Down

Cancel