Hi,
I recenetly installed a RED at a remote site and cousn't get it to provide a stable connection back to our UTM.
Looking at the UTM logs it constantly cycles with the following
This thread was automatically locked due to age.
Hi,
I recenetly installed a RED at a remote site and cousn't get it to provide a stable connection back to our UTM.
Looking at the UTM logs it constantly cycles with the following
Is it the only RED connection you have or do you have others that are working as expected?
Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.
Hi Richard Priest,
I have had issues with a RED15, and the first thing I always do is switch off compression, Sophos has never fixed this properly, and also I have had issues with the MTU size on the RED end...
The RED15 in a Data-Center it would disconnect every 3-4 days, until I checked the firmware and found that the MTU was set incorrectly, so updated firmware and changed MTU, now it would only disconnect every 2-3 weeks.
then if it did disconnect and then not re-connect I would reboot the router in front of the RED and all would be fine (for the next couple of weeks).
I have a SG310 on a 40/100 fibre circuit, the data-center had 10/100 Ethernet circuit connected via a router (many were tried, finally settled on Draytek283x) and the RED15 was behind the router. I had no issues until the 9.5 updates then it all went south.
I was using this as a (off-site) backup so this would be constantly running at full tilt all the time. Loading may have been another issue to contend with.
I hope this helps you out
XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!