Thread Info
  • State Verified Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 9 replies
  • Subscribers 4 subscribers
  • Views 11328 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Remote reboot of a RED - How??

Argo

I am unable to find any solution on how to reboot a RED unit.

I have found how to switch off the interface via the GUI, and also the ideas page for this feature.

but am unable to find any article about how to reboot the physical device unless it is unplugged at source.

any help appreciated.



This thread was automatically locked due to age.
Parents
  • 0

    Does toggling the enabled/disable button for the RED under RED Management > [Server] Client Management cause a reboot?  


    Tim

  • 0 in reply to TimHansen

    this only disables the interface, and doesn't reboot the RED15. :(

    XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
    Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!

  • 0 in reply to Argo

    Darn.  I don't see there being an easy way to reboot them then, other then disabling the service as a whole, unplugging the power from the device or making a configuration change.  Alternatively you could login to the UTM via SSH, get the REF_ number of the red ( cc > red > servers@ ) and then enable debugging of the RED ( OBJS > REF_ > debug_level=1 > w ).  This should force a reboot in order for the RED to enter debug mode.  Of course this would depend on your comfort with navigating the cc in the backend.  

    Tim

  • 0 in reply to TimHansen

    Hi Tim,

     

    thanks for the info, although i am comfortable with the back-end, I was unable to see anyway of rebooting the device, unless it was to remove the power completely!

    I did see the Ideas section asking for this option seems like even the XG does not have this feature, so might be a good option to have.

    XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
    Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!

  • 0 in reply to TimHansen

    TimHansen said:
    order for the RED to enter debug mode.

    Tim, can you explain how to access this debug information? i have problem with a RED15 that become unreachable. RED Tunnel LED is green, but UTM lost the connection. Only way is to cycle power the RED.

  • 0 in reply to UThomas

    Thomas, if the RED is unreachable from the UTM, likely it won't receive the command to go into debug mode and thus won't restart.  But feel free to give this a try.  

    In shell on the UTM:

    cc
    OBJS
    itfhw
    red_server
    REF_<red experiencing issue> (eg. REF_ItfRedReds1Red50)
    debug_level = 1
    w

    Tim

  • 0 in reply to TimHansen

    thats clear, but were can I read the debug information? in the UTM RED log?

Reply Children
Unfiltered HTML