This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[9.102][BUG]DNAT creates Network Definition

Hi,

i have created a DNAT Rule (like Szenario 2 : How to Port Forward Service Ports with NAT: Astaro Security Gateway)

After Rule creatation a Service Definition will be created and after each on/off of DNAT rule it will be re-created...

I use UTM 9.1 latest Patch Level.

Any hints? It's very annoying to delete wasted stuff...

This thread was automatically locked due to age.

Parents

0 ipzipzap over 11 years ago

Same here :-/
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 11 years ago in reply to ipzipzap

What is more annoying is that it creates this even when you use an existing definition. If you rename it a new one is created.
Definition table full of junk.

Not very good.

ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 GuyFawkes over 11 years ago in reply to rfcat_vk

Definition table full of junk.

Yes, same probleme here!
Is there a open call to this issue?

Nice greetings
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 GuyFawkes over 11 years ago in reply to rfcat_vk

Definition table full of junk.

Yes, same probleme here!
Is there a open call to this issue?

Nice greetings
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data