This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multicast Routing (PIM-SIM): how to?

Dear all

My provider recently enabled IPTV over Multicast. 
I did try it make it available on my network using Sophos UTMs PIM-SIM. 
I have worked out all messages on the firewall (IGMP Blocking) and PIM-SIM logs: it seems to connect to the RP.

.. but, no luck so far.

Could someone give me a hand with it an review my settings?

Interfaces
- eth1 (WAN), IGMP Version 2 enabled, Priority 0
- eth0 (LAN), IGMP Version 2 enabled, Priority 0

RP Routers
- HOST: <IP of providers RP>
- Priority 1
- Multicast Group Prfixes: 224.0.0.0/4

The streams go to a 239.x.x.x address on UDP port 5000. Something to consider here?

Routes
- Route Type: Inteface Routes
- Network: Internal (LAN) Network
- Interface: Internal (LAN)

My mistake is likely here in the routes: I didn't quite understood whats routing between what.

Any ideas are very appreciated.

Kind regards

Oli

 



This thread was automatically locked due to age.