Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 4 subscribers
  • Views 2884 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple WAN IPs to different ports/zones

William Metzler

I am fairly new with using a Sophos UTM.  I have a /29 block of public IPs with the first IP in my WAN configuration and the other 4 IPs in the additional interfaces under it.  I have internet working fine on Port 1 using the first public IP in the block of x.250 with an internal of 192.168.10.1.  What I am trying to figure out is setting it so Port 8 will use the next public IP of x.251 and an internal of 192.168.20.1.  How do I go about configuring it so that the zone associated to port 8 will use the x.251 for the WAN traffic?  



This thread was automatically locked due to age.
  • 0

    Hi William,

    insert the additional WAN-IPs under Interfaces and Routing ->Interfaces -> Additional Addresses, then define different masquerading rules under Network protection -> NAT -> Masquerading for your different internal networks.

    (my UTM "speaks" german, so perhaps the definitions above are a little bit different ;-) )

    Viele Grüße / Best Regards,
    Manu

    - CISO -
    - Sophos SCA & Partner-

Unfiltered HTML