Uplink Balancing not switching back to higher priority Interface

Hi, Daniel, and welcome to the UTM Community!

That looks good to me, so I would have to suspect your ISP's equipment.  Does making the change recommended in #7.7 in Rulz resolve this issue?

Cheers - Bob

Hi Bob,

thanks for the input and sorry for the late reply. couldnt check that any earlier. i did what you suggested and set fixed speed and duplex on the firewall interfaces as well as on the switches. unfortunately it didnt work (same problem). maybe what shoud be considered is the network design for this particular connections:

WAN Connection: UTMs WAN Interface (eth1) -> connected to switch VLAN 2 (untagged) -> WAN (fibre) Router (also connected to VLAN 2 same switch, untagged)
LTE-WAN Connection: UTMs free interface (eth5) -> connected to switch VLAN 3 (untagged) -> LTE Bridge (also connected to VLAN 3 same switch, untagged)

keep in mind there are 2 UTMs (HA Mode) with the same wiring and VLAN switch ports. all switch ports (and firewall interfaces) are set to 1GB/s Full-Duplex.
i cannot change the switch-connected Interfaces on the WAN (fibre) Router and LTE-WAN Bridge to fixed speed and duplex because we have no access to these devices.
Do you think it is necessary to set fixed speed/duplex on these 2 devices too?

On the switch i can see those 2 devices auto-negotiated to 1GB/s FD also.

thanks for your ideas.

regards

Hi Bob,

thanks for the input and sorry for the late reply. couldnt check that any earlier. i did what you suggested and set fixed speed and duplex on the firewall interfaces as well as on the switches. unfortunately it didnt work (same problem). maybe what shoud be considered is the network design for this particular connections:

WAN Connection: UTMs WAN Interface (eth1) -> connected to switch VLAN 2 (untagged) -> WAN (fibre) Router (also connected to VLAN 2 same switch, untagged)
LTE-WAN Connection: UTMs free interface (eth5) -> connected to switch VLAN 3 (untagged) -> LTE Bridge (also connected to VLAN 3 same switch, untagged)

keep in mind there are 2 UTMs (HA Mode) with the same wiring and VLAN switch ports. all switch ports (and firewall interfaces) are set to 1GB/s Full-Duplex.
i cannot change the switch-connected Interfaces on the WAN (fibre) Router and LTE-WAN Bridge to fixed speed and duplex because we have no access to these devices.
Do you think it is necessary to set fixed speed/duplex on these 2 devices too?

On the switch i can see those 2 devices auto-negotiated to 1GB/s FD also.

thanks for your ideas.

regards

"i cannot change the switch-connected Interfaces on the WAN (fibre) Router and LTE-WAN Bridge to fixed speed and duplex because we have no access to these devices.
Do you think it is necessary to set fixed speed/duplex on these 2 devices too?"

Yes, those are the ones that would need to be set if you go back and look at #7.7 in Rulz.  Your ISP can do that.  Have them set them to 1Gbps/Full, and I bet the same setting on the UTM will cause your problem to mysteriously disappear.[;)]

Cheers - Bob