Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 4 subscribers
  • Views 8038 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Interface Ethernet Bridging to create a switch

RyanHosiassohn

Hey All, 

Im not to sure if this has been discussed at all . 

I was told in order to make a switch on the SG UTM was to create an Ethernet Bridge group with the interface that weren't being used. 

I did so but it seems that somehow after making the group, No data was going through the interfaces that were including into the bridge interface. 

If i connected to the main bridge interface and everything else into a switch it would work. 

But for example. Eth0 - Main LAN interface. I added eth1,2 to this. If I connected anything into 1 or 2 no data was going through the firewall, SIP was a major issue as well.

Any help of info would be much appreciated :)



This thread was automatically locked due to age.
Parents
  • 0

    I think you will also need to create a firewall rule allowing traffic from the bridge to the bridge. Sounds strange, but all traffic passing through the UTM's interfaces needs to be allowed in order to be passed through......

    Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Reply
  • 0

    I think you will also need to create a firewall rule allowing traffic from the bridge to the bridge. Sounds strange, but all traffic passing through the UTM's interfaces needs to be allowed in order to be passed through......

    Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Children
Unfiltered HTML