Using UTM 9.351-3, I have a clear memory leak as easily shown by the Weekly Reports I have sent to myself (it *IS* in the daily, but so little that it isn't as obvious as in the Weekly).
Sure, rebooting the UTM temprorarily resolves the high MEM usage, but it always just comes back up.
What can I do to try to figure out why the MEM is leaking like this?
So, Week3:
And swap usage is still increasing... I am not entirely convinced that this is NOT a memory leak... It has ALL the indications of a memory leak. I am going to leave this be and see how high this will go.
Here is one of my installs with Everything turned on including WAF, SMTP proxy and wifi but IPS is turned off and using single scan with 2.5GB ram with swappiness setting at zero. How much ram are you using and what do you have enabled? By the way I am still on the 9.31x branch running a vm.
Edit: Here is another one from this week. Don't know why it dips at the end. Maybe different patterns.
and top output
Here is one of my installs with Everything turned on including WAF, SMTP proxy and wifi but IPS is turned off and using single scan with 2.5GB ram with swappiness setting at zero. How much ram are you using and what do you have enabled? By the way I am still on the 9.31x branch running a vm.
Edit: Here is another one from this week. Don't know why it dips at the end. Maybe different patterns.
and top output
