This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

out of band management interface

HI there,

I am setting SG550 UTMs and looking for a way to make a kind of OOB management interface for web admin access with a management interface.
But I found that the Management interface(labeled as Management on the UTM) seems to be in a same routing table, so it can't have separate default routing for the interface.
I want to access the utm through the management interface from any network.

Any clue for this requirement?

Thanks in advance.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

You don't need to waste an interface for this and you are correct that there isn't an isolated management port possible on UTM. WebAdmin can be accessed via any interface, based on the settings you make in the Management > WebAdmin Settings > General section.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

You don't need to waste an interface for this and you are correct that there isn't an isolated management port possible on UTM. WebAdmin can be accessed via any interface, based on the settings you make in the Management > WebAdmin Settings > General section.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data