This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New interface doesn't show up when in HA mode

I have the virtual UTM9 appliances in an HA pair.

I added a new network/interface to both VM's and rebooted them.

When i go into the interfaces (or hardware) tab and try to add the new one, there is nothing there. It should be eth6, but all I have are eth0-5 like I did before.

Any ideas?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

Check the Kernel Messages log to see if you find any related errors.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

Check the Kernel Messages log to see if you find any related errors.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data