This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Make UTM running in routing mode

Hi all,

I'm new to Sophos UTM. I've just deployed an UTM 9 on a Virtual Machine. The topology is:
LAN -------- (internal nic) (external nic) ------- Peplink.

There are many vlans in internal network. I was able to connect internet.
On the Peplink, I have some outbound rules that assign WAN connections depend on Vlans (something like policy based routing). But when traffic go through UTM, they are all NATed to the external IP of UTM. So the policy based routing on the Peplink doesn't make sense. Could you show me how can I make the UTM not running NAT. I would like the IP address of workstation won't be changed when go through UTM.

Thank you all.

This thread was automatically locked due to age.

Parents

0 emin3m over 9 years ago

Hi,

I use UTM for web filtering, authenticate wireless users. Am I able to do that if I bridge 2 interfaces? Now my VM just have 2 interface, so I don't know how to bridge them cause I need at least 1 interface connected to access the configuration web.
I just would like to test the function of UTM, so I deployed it on a VM only have 2 interfaces, while I have 7 WANs so I need to use Peplink.
Please give me some advice.
Thank you so much.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 emin3m over 9 years ago

Hi,

I use UTM for web filtering, authenticate wireless users. Am I able to do that if I bridge 2 interfaces? Now my VM just have 2 interface, so I don't know how to bridge them cause I need at least 1 interface connected to access the configuration web.
I just would like to test the function of UTM, so I deployed it on a VM only have 2 interfaces, while I have 7 WANs so I need to use Peplink.
Please give me some advice.
Thank you so much.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data