This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG220 with UTM9: Logging of Load Balancing

We have 2 ASG220 with UTM9 in use. They are configured in ACTIVE-ACTIVE-Cluster-mode.

Is there any logging of the Loadbalancing-Configuration? I need information about which port is on which node in use. I think, the HA-log does not give information about that.

Thx.

This thread was automatically locked due to age.

Parents

0 BAlfson over 9 years ago

I don't believe that information is collected. What question stimulated asking how to do that?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 travelinlight over 9 years ago in reply to BAlfson

... What question stimulated asking how to do that?

Cheers - Bob

Thx Bob!

A partner asserted, that one of his components has problems with the loadbalancing of our ASG-Cluster. I would like to proof, that the ASG is not the reason for the problems, therefore I need logs...

Maybe I should collect some more information of the third party components and a description of the error pattern...
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 travelinlight over 9 years ago in reply to BAlfson

... What question stimulated asking how to do that?

Cheers - Bob

Thx Bob!

A partner asserted, that one of his components has problems with the loadbalancing of our ASG-Cluster. I would like to proof, that the ASG is not the reason for the problems, therefore I need logs...

Maybe I should collect some more information of the third party components and a description of the error pattern...
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data