This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

APN Settings allways default

Hi Guys,
I try to configure a LTE Stick with the UTM and also specify a dedicated APN of my Company.

The Interface of the LTE Stick always turns back to default.

I haven't seen anything in the Logs maybe I may give it a try with the CLI.

Or any other suggestions ?

thnx in advance

This thread was automatically locked due to age.

Parents

0 freighter over 9 years ago

ok,
found a sollution

going to CLI
# cc
# OBJS
#*-> go to your device
# auto_apn=0
# apn=''

THIS IS NOT SUPPORTED BY SOPHOS
the AUTO_APN hook will not be editable in the WUI.

best regards
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 freighter over 9 years ago

ok,
found a sollution

going to CLI
# cc
# OBJS
#*-> go to your device
# auto_apn=0
# apn=''

THIS IS NOT SUPPORTED BY SOPHOS
the AUTO_APN hook will not be editable in the WUI.

best regards
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data