Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 2 subscribers
  • Views 823 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IP Address Design Questions

JoshuaHill
Hello Everyone,

I am curious as to how to address the UTM if its facing the Circuit.
I know one interface is going to point to the WAN however, What if you have an existing LAN network? How would you go about IP'ing the LAN interface? Right now have a /30 on network that is totally separate from my LAN and im seeing problems. Is there another way to accomplish have LAN traffic to use the /30 link without natting this? I thought about natting on the Router which is connected to the Firewall's LAN interface but how would i tell the different between addresses? Any thoughts?

Thanks,


This thread was automatically locked due to age.
Parents
  • 0
    Perhaps you could click on [Go Advanced] below and attach a picture of your topology?

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    Perhaps you could click on [Go Advanced] below and attach a picture of your topology?

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Unfiltered HTML