This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

missing ip address

Today I have updated my UTM and all on a sudden lost connectivity to UTM.

Somehow managed to get access to the shell and set ip address on eth3(internal) and could connect to web interface.

However when I log on to the web interface both interface are showing as down. When I try to enable (either internal eth3 or external eth2), I get the following error message.

"An interface object may not lack an interface hardware"

If I want to these network interfaces too attached to a hardware, I get the following error message

"The interface that is used for the current session can not be deactivated or deleted."

I have attached screenshot of interfaces that is currently showing in web interface.

This thread was automatically locked due to age.

0 ashabc over 9 years ago

Anyone any help?
Cancel
Vote Up 0 Vote Down

Cancel
0 ashabc over 9 years ago in reply to ashabc

Ended up reinstalling the UTM and restored from last backup. Not a good solution at all.
Cancel
Vote Up 0 Vote Down

Cancel
0 vilic over 9 years ago

I've had similar problem but with iView, described in this post:

up2date 1.002-9 crashed Internal interface

In my case that was Hyper-V 2012R2 based VM only for testing purposes. I had a snapshot before up2date, so didn't bother to waste much time on resolving the issue.
Cancel
Vote Up 0 Vote Down

Cancel