This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No hostname shown in IPv4 lease list

Hello all,

I have a strange issue here.
Although I have DHCP reservations and network definitions for my hosts, there's no hostname displayed for the clients in the DHCP lease list.

Please see the screenshots attached.

How do I display the hostname in the leases list?

Bjoern

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi,
Were these created in a older version of the UTM, and then you upgraded to 9.1?
Or were they created in 9.1?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 11 years ago in reply to BarryG

I should have also added my dhcp IPv4 lease table is empty while the IPv6 table has entries.
The static table has text advising that the entries are managed by network definitions where as the IPv4 table used to have this text but no longer does.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 11 years ago in reply to BarryG

I should have also added my dhcp IPv4 lease table is empty while the IPv6 table has entries.
The static table has text advising that the entries are managed by network definitions where as the IPv4 table used to have this text but no longer does.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data