Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 3 subscribers
  • Views 6970 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to check IPSEC-VPNs by SNMP?

PaulKerl
Hello,

I try to get the ASG 7.007 monitored my SNMP. So far works fine but:

If i do a snmpwalk to the Astaro on IPSEC0 this will output sth like this:

RFC1213-MIB::ifOperStatus.7 = INTEGER: up(1)

So IPSEC0 is online. 1-4 is offline.

I have two tunnels online but only IPSEC0 is shown as up.

How can I get both IPSEC tunnels monitored by SNMP?

Thanks...

HuGO


This thread was automatically locked due to age.
Parents
  • 0

    I would also like to know how to monitor an IPSec tunnel through SNMP.

    I see that the IfInOctets registry of the ipsec0 or tunnel interface always gets 0.

  • 0 in reply to MaxwellOliveira

    Olá Maxwell,

    On the 'Notifications' tab of 'Management - Notifications', you can see that there are only very few SNMP messages available.  Do you see there what you wanted?  If not, please share your concern.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0 in reply to MaxwellOliveira

    Olá Maxwell,

    On the 'Notifications' tab of 'Management - Notifications', you can see that there are only very few SNMP messages available.  Do you see there what you wanted?  If not, please share your concern.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Unfiltered HTML