This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using the same DHCP range for LAN and Wireless

Is it possible to use the same DHCP range for both LAN and Wireless on the UTM 9? I'd like both LAN and Wireless to use a range like: 10.0.0.100 - 10.0.0.150 / 255.255.255.0 so that both clients Wireless and LAN can communicate.

Any help would be much appreciated.

This thread was automatically locked due to age.

Parents

Scott_Klassen over 8 years ago

You can use a bridge to LAN wireless. Not really necessary for communication though. This can be achieved with firewall rules to allow the traffic.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Scott_Klassen over 8 years ago

You can use a bridge to LAN wireless. Not really necessary for communication though. This can be achieved with firewall rules to allow the traffic.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data