This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

POP3 Errot Can't bind

Hello,

I have a "UTM" home edition version 9401-11 but I had the same problem in 9355 release. when I activate the pop3 service following a restart on the first day it works. thunderbird then no longer able to recover emails. in the logs I have "Fatal: Can't bind on port 8110: Address already in use". you know little or comes trouble. Thank you.

This thread was automatically locked due to age.

Parents

0 TheBalmasque over 8 years ago

I'm experiencing the same problems right here with the firmware version 9.355-1.

First everything worked fine, but after an restart it dosen´t work anymore...

There is already a thread refering to this issue with an workarround:

community.sophos.com/.../49681

But i dont want to loose all my reports and logs...
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 8 years ago in reply to TheBalmasque

The data in the graphs and in Reporting are lost, but the logs are left intact by that command.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 TheBalmasque over 8 years ago in reply to BAlfson

BAlfson said:

The data in the graphs and in Reporting are lost, but the logs are left intact by that command.

Cheers - Bob

Thank you for your answer. [Y]

I´ve entered the command "/etc/init.d/postgresql92 rebuild" and rebooted the system.

Now it works again properly. [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 laurentlunes over 8 years ago in reply to TheBalmasque

The solution worked for me too.

Thank you
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 laurentlunes over 8 years ago in reply to TheBalmasque

The solution worked for me too.

Thank you
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data