This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot open iView reporting

Hello,

I downloaded iView and performed a fresh install on a host running Hyper-V.

After performing basic configuration, I tried accessing the iView reporting page at *iviewIP*:8000 but the web page is not opening.

Has anyone encountered this before with iView ?

This thread was automatically locked due to age.

Parents

0 teched_01 over 9 years ago

Eight months ago I pointed out that iView uses http on port 8000 and not https.
https://community.sophos.com/products/unified-threat-management/astaroorg/f/63/t/57584

This generation of iView appears built on an OS and configuration foundation (command line, port 4444) similar to that of UTM/SUM, so some diagnostic techniques there are similar. The reporting (port 8000) portion appears more Cyberoam.

If you are a commercial licensee, or prospective commercial licensee, please inquire through the official support channels and share any insights or answers with the rest of us.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 teched_01 over 9 years ago

Eight months ago I pointed out that iView uses http on port 8000 and not https.
https://community.sophos.com/products/unified-threat-management/astaroorg/f/63/t/57584

This generation of iView appears built on an OS and configuration foundation (command line, port 4444) similar to that of UTM/SUM, so some diagnostic techniques there are similar. The reporting (port 8000) portion appears more Cyberoam.

If you are a commercial licensee, or prospective commercial licensee, please inquire through the official support channels and share any insights or answers with the rest of us.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data