Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 6 subscribers
  • Views 10481 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Restore Backup from one SG210 to another SG210 failed

GerdNesch

We have a SG210 UTM with Firmware Release 9.501-5. We made a backup of the configuration for restoring it to a new hardware (also a SG210 UTM).

The new SG210 has a 30day trail license and was manually updated to 9.501.5 and has the default IP Adress 192.168.0.1.

Now we tried to restore the backup configuration from UTM1 to UTM2.

You can import configuration file and apply it but the only result is, that you are logged off from webadmin.

When you reboot UTM2 nothing has changed.

After that I tried it with the original license-file, but nothing was changed.

Any Ideas ?

 

Regards Gerd



This thread was automatically locked due to age.
Parents
  • 0

    Gerd, I have the following procedure when a client is replacing an identical device (e.g., a 210 with a 210):

    1. On the active NICs on the current 210, set the 'Virtual MAC' to the 'MAC Address'.
    2. Configure the current 210 to be node 1 in "Hot Standby" in 'High Availability'.
    3. Factory reset the new 210.
    4. With the new 210 powered off, connect it identically to the current 210 and connect eth3 on both UTMs.
    5. Power up the new 210.
    6. When the new 210 shows as "READY" in HA, power down the old 210 and remove it.

    Erledigt!

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0

    Gerd, I have the following procedure when a client is replacing an identical device (e.g., a 210 with a 210):

    1. On the active NICs on the current 210, set the 'Virtual MAC' to the 'MAC Address'.
    2. Configure the current 210 to be node 1 in "Hot Standby" in 'High Availability'.
    3. Factory reset the new 210.
    4. With the new 210 powered off, connect it identically to the current 210 and connect eth3 on both UTMs.
    5. Power up the new 210.
    6. When the new 210 shows as "READY" in HA, power down the old 210 and remove it.

    Erledigt!

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Unfiltered HTML