This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After up2date, slave node death

Hi, after the reboot of the slave node after the up2date from 9.413-4 to 9.500-9 release, the boot stops with this error

If I try the command fsck /dev/sda6

$ sh: fsck.ddf_raid_member: not found

Any idea?

The node master is running ok.

Thanks.

This thread was automatically locked due to age.

Parents

0 Varick Williams over 7 years ago

I am having this issue as well. Something with the last update must have change the parameter.

Varick
Cancel
Vote Up 0 Vote Down

Cancel
0 mod2402 over 7 years ago in reply to Varick Williams

Hi there,

I had the same Problem on a hyper-v system. Solution = Rebuild second node and rebuild HA. That is done in 10 Minutes.

regards

mod
Cancel
Vote Up 0 Vote Down

Cancel
0 Varick Williams over 7 years ago in reply to mod2402

I am not clustered nor virtual. I running UTM on a single HD? Any suggestions?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Varick Williams over 7 years ago in reply to mod2402

I am not clustered nor virtual. I running UTM on a single HD? Any suggestions?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 mod2402 over 7 years ago in reply to Varick Williams

Hi Varick,

the subject is

After up2date, slave node death

Please create a new threat with your issue. That's not the same.

Regards

mod
Cancel
Vote Up 0 Vote Down

Cancel
0 Varick Williams over 7 years ago in reply to mod2402

Yes Mod while I appreciate the subject line and understand I may not be configured for clustering, I have the exact same symptom and error messages caused by the same up2date to version9.500.9. I can start my own thread but searches in the forum led me here because of the error message. Something in that release caused this error.
Cancel
Vote Up 0 Vote Down

Cancel
0 papali over 7 years ago in reply to Varick Williams

I contacted the sophos technical support but could not give me support because it was not possible to connect it remotely to a PC that I connected via the serial port to the slave node, then I decided to reinstall the slave node and rebuild the cluster.

I tried connecting from a pc to the master node (that worked perfectly) but not even there it was possible to connect via serial port.
Do I think it's only possible with appliances?
Cancel
Vote Up 0 Vote Down

Cancel
0 mod2402 over 7 years ago in reply to papali

Hi papali,

you should connect via ssh to the master and then you can switch to slave with ha_utils ssh

regards

mod
Cancel
Vote Up 0 Vote Down

Cancel
0 papali over 7 years ago in reply to mod2402

Hi mod2402, I tried, but there was only 1 node, probably the slave node failed to load the modules needed to be recognized as online?
Cancel
Vote Up 0 Vote Down

Cancel