Can't ping across subnets.

Not a lot to go on here, but is ping allowed through the UTM firewall between subnets? Whats your logs telling you?

Sorry for lack of info--I'm configuring the appliance only for Spam filtering and email encryption--none of the other firewall services are in place. I am testing the UTM in between the firewall and the mail server, as a replacement for our current Sendio appliance.  The 2 networks are 192.168.1.x and 192.168.100.x.  The UTM is on the 192.168.1.x network, and can't ping any .100 addresses (they can't ping the UTM as well).

Thank you,

Pretty sure you're going to run into some default firewall settings anyway. Check the ICMP settings on the firewall - advanced page. 

Your last statement  "The UTM is on the 192.168.1.x network, and can't ping any .100 addresses (they can't ping the UTM as well)." But earlier you said "the two subnets are fully routed and other devices on the network can ping each other."

Nothing makes sense. Anyway, check ICMP through gateway and Gateway forwards pings. Or, the logs tell you everything you'll need to know instead of us shooting in the dark

Somehow my reply from yesterday was lost....

I have checked everything under ICMP, but stillno luck.  What I meant by "fully routed" is that all other devices on the network can see and ping other devices between subnets.  The UTM is the only device having a problem.

Thanks,

Somehow my reply from yesterday was lost....

I have checked everything under ICMP, but stillno luck.  What I meant by "fully routed" is that all other devices on the network can see and ping other devices between subnets.  The UTM is the only device having a problem.

Thanks,

James, there are two tricks here.  One is that the "Any" Service does not include ICMP, specifically not Ping, and the other is that you need firewall rules to regulate ping traffic between networks.  Any better luck now?

Cheers - Bob

There were no defined firewall rules (I presumed it would be open), but I created one to address both ping and https. Here are the current settings for both ICMP and the firewall rule (baptist homes is 192.168.1.0 /24, Providence Point is 192.168.100.0 /24).  Still no luck, thanks.

Please show a picture of the Interfaces on the 'Interfaces' tab.

Cheers - Bob

What/where are the "Baptist Homes" and "Providence Point" subnets?

Cheers - Bob

Baptist Homes is 192.168.1.0 /24 (the UTM is on this subnet), and Providence Point is 192.168.100.0 /24.

gateway on the UTM is the same gateway for the clients that can actually ping the other side?

Where are these subnets?  Is Baptist Homes inside the Ethernet segment that the Internal interface connects to?  Is Providence Point behind another router in your network?

Cheers - Bob

I did see where the default gateway was not set for the interface. However, I corrected it, restarted and still no luck.

The Baptist Homes subnet (192.168.1.0 /24) is where the internal interface connects to.  Providence Point (192.168.100.0 /24) is a separate physical location, so yes the two subnets can see each other.

Obviously this gateway that you set has routes to the other subnet? Have you checked your logs yet lol