Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 5 subscribers
  • Views 2654 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to backup hardware changes on utm9 software install

waghelak

Hi,

I have installed Sophos utm home on a hardware where I had to do changes via console once installed due to having HDMI and no VGA.

I also changed my NIC numbering i.e. from (eth 0 and 1) to (eth 1 and 2). 

Currently it is working all fine and haven't really got the time to mess with it anymore but I recall having done a factory reset and I had to console into the box and do all the changes again.

Is there a way I can back this changes and if in future something goes wrong I could then just restore the correct changes?

Below is the link to the original thread and how I managed to do the installation.

https://community.sophos.com/products/unified-threat-management/f/52/t/77989

Thanks



This thread was automatically locked due to age.
  • 0

    There's no information about what you did at that link.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson

    Hi

    Sorry there was another link through that which is below

    Basically I could not install UTM home as I only had hdmi connection and installed it on another PC after which I had to sort the NIC settings manually.

    I did a lot of changes and just wondered whether a restore would fix those issue in future or would I have to remember how I initially installed it.

    Thanks

Unfiltered HTML