Trying to setup UTM 9.3 with Verizon FIOS. I currently have connected as follows:
Verizon FIOS router LAN port --> UTM WAN port (eth2) -->UTM LAN port (eth1) --> switch --> Wireless router LAN port (used as access point).
The verizon router is 192.168.1.1 with DHCP enabled for range 192.168.1.100 - .200 (do I need DHCP here? I do have a couple of devices directly connected to this router bypasing UTM)
I have UTM LAN set to 192.168.1.2. It seems I may need to enable DHCP here since downstream clients are not getting address from Verizon router. I tried enabling DHCP with range 192.168.1.10 - .99 with no luck
All subnet masks are 255.255.255.0. I will need all internal LAN devices to reach each other - a wireless client connected to the router needs to hit a printer connected to the Verizon router, etc.
The wireless router is set to 192.168.1.3 no DHCP thinking it would pick up address from something upstream.
I'm currently not getting internet access downstream of UTM. Using Tools-->Ping check on UTM I can ping internet addresses by IP but not by name.
Suggestions greatly appreciated.
This thread was automatically locked due to age.
