This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[9.312] Intel 82572EI e1000e Hardware Unit Hang

Hi,

I have rebuilt one of my firewalls, using a Z87 motherboard and an Intel 82572EI PCIe NIC as eth1/WAN.

I'm now getting a LOT of e1000e "eth1: Detected Hardware Unit Hang" messages, and the firewall stops responding on ALL interfaces including LAN.

I notice the UTM says it is disabling TSO, but that doesn't seem to be enough.

If I run
ethtool -K eth1 tso off gso off gro off
it gets MUCH better (maybe solved).

Where should I add this to init or udev?

lspci:
01:00.0 Ethernet controller: Intel Corporation 82572EI Gigabit Ethernet Controller (Copper) (rev 06)

Thanks,
Barry

This thread was automatically locked due to age.

Parents

0 RussellChalmers over 9 years ago

So far, it has worked [:)]

I ran the command and then I repeated the updates to Linux and Windows 10 Preview VM's that caused my previous issues with the NIC - not a single failure.

Thanks for your help.

Sophos XG 17.0 RC-1 - Home - Bridged mode behind Sky Q Hub / Sky Fibre Max (80/20)

Custom UTM PC (Intel Z97 iTX, Intel Core i3, 8GB DDR3, 120GB SSD, 2 Intel NIC's, Corsair AIO)
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RussellChalmers over 9 years ago

So far, it has worked [:)]

I ran the command and then I repeated the updates to Linux and Windows 10 Preview VM's that caused my previous issues with the NIC - not a single failure.

Thanks for your help.

Sophos XG 17.0 RC-1 - Home - Bridged mode behind Sky Q Hub / Sky Fibre Max (80/20)

Custom UTM PC (Intel Z97 iTX, Intel Core i3, 8GB DDR3, 120GB SSD, 2 Intel NIC's, Corsair AIO)
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data