Hi,
I have rebuilt one of my firewalls, using a Z87 motherboard and an Intel 82572EI PCIe NIC as eth1/WAN.
I'm now getting a LOT of e1000e "eth1: Detected Hardware Unit Hang" messages, and the firewall stops responding on ALL interfaces including LAN.
I notice the UTM says it is disabling TSO, but that doesn't seem to be enough.
If I run
ethtool -K eth1 tso off gso off gro off
it gets MUCH better (maybe solved).
Where should I add this to init or udev?
lspci:
01:00.0 Ethernet controller: Intel Corporation 82572EI Gigabit Ethernet Controller (Copper) (rev 06)
Thanks,
Barry
This thread was automatically locked due to age.
